Bulldog Security RS1300E Installationsanleitung

CONTENTSALARM AND REMOTE CONTROL STARTERMODEL RS1300EINSTALLATION GUIDE•OWNER’S GUIDETechnical AssistanceAll tech personnel are expertly qualified to

OPERATOR PROGRAMMING INSTRUCTIONS9NOTE: When testing the door pin wire, make sure the domelight is on. Some vehicles, if the door is left openfor a pe

10Adding Additional RemotesPress and hold brake. Next, press and hold Button #1 on the working remote until the parking lightsflash once, release. Pre

HOW TO USE YOUR REMOTE TRANSMITTER10Automatic Start - OnPress and hold brake. Press and hold Button #2 until the parking lights flash twice. Release.

SYSTEM FEATURESSYSTEM COMPONENTS1REQUIRED TOOLSYour system includes:2- Four Button Remote Transmitters1- Main Control Module1- 16-Pin Wire Harness1- 5

TECHNICAL ASSISTANCEBEFORE YOU BEGIN2PRECAUTIONSThis system is designed for use with vehicles equipped with fuel-injected,gasoline engines with automa

MAKING WIRING CONNECTIONS3USING YOUR TEST PROBETo operate your test probe, connect the black clip to a good chassis ground. Connect the red clip to a

44. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection.Secure with wire ties as shown.3. Lay upper twisted pair

5Note: Remove any paint belowthe spade connector.Factory BoltSpade ConnectorBlack Ground Wire1. If your vehicle has only one (1) ignition wire, as mos

6NEUTRAL SAFETY SWITCHPARKING LIGHTS (+12V only with parking lights on)Turn the parking lights to the ON position. (NOT YOUR HEADLAMPS).Probe the wire

7CONNECTING THE WIRING HARNESSANTENNA PLACEMENTOPTIONAL CONNECTIONSGroundPRE-1996 GM REAR WHEEL DRIVES WITH PURPLE CRANK WIRE Optional part #775 requi

8light will glow bright on both the lock and the unlock wires. Press and hold the lock button on theswitch and test the lock wire. The correct wire wi