Bulldog Security 781 Installationsanleitung

CONTENTSREMOTE STARTERMODELS RS1200/RS1200EINSTALLATION GUIDE•OWNER’S GUIDETechnical AssistanceAll tech personnel are expertly qualified to answer any

OPERATOR PROGRAMMING INSTRUCTIONS9TRUNK RELEASE AND SLIDING VAN DOOR RELEASE (+)Locate the trunk release or sliding van door release wirecoming from t

HOW TO USE YOUR REMOTE TRANSMITTER10Tachless Mode - ONPress and hold the brake pedal. Press and hold Button #3 until the parking lights flash three (3

Starting the Vehicle with the Remote TransmitterPress and release button #1 (start). The parking lights will flash once, confirming the car starter re

SYSTEM FEATURESSYSTEM COMPONENTSTECHNICAL ASSISTANCE1REQUIRED TOOLS2 Four-Button Extended Range Remotely start your car to run the heater, air conditi

BEFORE YOU BEGIN2PRECAUTIONSUSING YOUR TEST PROBECongratulations, you have purchased one of the most advanced remote starter systems ever made. Your n

MAKING WIRING CONNECTIONS3NOTE: In most cases you should not cut your vehicle wire in two.1. Strip back two inches of insulation on the wire from the

44. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection.Secure with wire ties as shown.3. Lay upper twisted pair

5Note: Remove any paint belowthe spade connector.Factory BoltSpade ConnectorBlack Ground Wire1. If your vehicle has only one (1) ignition wire, as mos

6NEUTRAL SAFETY SWITCHCONNECTING THE WIRING HARNESSPARKING LIGHTS (+12V only with parking lights on)Turn the parking lights to the ON position. (NOT Y

7ANTENNA PLACEMENTFACTORY ANTI-THEFT SYSTEMSOPTIONAL CONNECTIONSControl ModuleAntenna WireAntenna TubeANTENNAFor best results, run the antenna (YELLOW

8on the switch and test the unlock wire. The correct wire will test (-) negative and the GREEN lightwill glow bright. Release the unlock button and th